EasyManuals Logo
Home>HP>Monitor>LP2275w

HP LP2275w User Manual

HP LP2275w
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Using the Accessory Rails
The monitor features accessory rails on the rear that may be used to mount optional devices, such as
the HP speaker bar, to the LCD monitor. Refer to the documentation included with the optional device
for detailed mounting instructions.
Figure 3-11 Using the Accessory Rails Feature
Removing the Monitor Pedestal Base
You can remove the monitor panel from the pedestal base to mount the panel on a wall, a swing arm,
or other mounting fixture.
This monitor has a Quick Release mechanism that allows you to easily remove and replace the monitor
panel to the pedestal base.
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the
power and signal cables are both disconnected. Also disconnect any USB cables that are connected to
the monitor.
1. Disconnect and remove the signal and power cables from the back of the monitor.
2. Slide the quick release latch (1) on the pedestal base to the side (either right or left).
16 Chapter 3 Setting Up the Monitor

Table of Contents

Other manuals for HP LP2275w

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP LP2275w and is the answer not in the manual?

HP LP2275w Specifications

General IconGeneral
3DNo
Panel typePVA
Pixel pitch0.282 x 0.282 mm
Response time6 ms
Display diagonal22 \
Display resolution1680 x 1050 pixels
Display technologyLCD
Vertical scan range48 - 85 Hz
Horizontal scan range30 - 93 kHz
Contrast ratio (typical)1000:1
Display number of colors-
Display brightness (typical)300 cd/m²
Supported graphics resolutions1280 x 1024 (SXGA), 1440 x 900 (WXGA+), 640 x 480 (VGA), 800 x 600 (SVGA)
Storage temperature (T-T)20 - 60 °C
Operating temperature (T-T)5 - 35 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)20 - 80 %
Non-operating relative humidity (non-condensing)5 - 90 %
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (max)85 W
Power consumption (standby)2 W
Power consumption (typical)56 W
Plug and PlayYes
Tilt angle range-5 - 30 °
Height adjustment100 mm
Cable lock slot typeKensington
Panel mounting interface100 x 100 mm
USB hub version2.0
HDMI ports quantity0
USB Type-A downstream ports quantity4
Product colorBlack
Country of originChina
Dimensions (W x D x H) (imperial)19.9 x 10 x 18.8 \
Package weight11300 g
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)253 mm
Width (with stand)506 mm
Height (with stand)477 mm
Depth (without stand)82.6 mm
Height (without stand)328 mm
Weight (without stand)8500 g

Related product manuals