HP MultiSeat ms6000 User Manual

Computer Setup—Security
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-4 Computer Setup—Security
Option Description
Setup Password Allows you to set and enable a setup (administrator) password.
Power-On Password Allows you to set and enable a power-on password. The power-on password prompt appears
after a power cycle. If the user does not enter the correct power-on password, the unit will not
boot.
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to:
● Lock legacy resources (appears if a setup password is set)
●
Enable/disable network server mode (appears if a power-on password is set)
●
Specify whether the password is required for warm boot (Ctrl+Alt+Delete) (appears if a
power-on password is set)
● Enable/Disable Setup Browse Mode (appears if a setup password is set) (allows viewing, but
not changing, the F10 Setup Options without entering setup password)
● Enable/disable Stringent Password (appears if a power-on password is set), which when
enabled bypasses the onboard password jumper to disable the power-on password.
See the Desktop Management Guide for more information.
Device Security Allows you to set Device Available/Device Hidden for:
●
Serial ports
●
Parallel port
● System audio
●
Network controllers (some models)
●
Embedded security device (some models)
●
SATA0
●
SATA1
● SATA2
●
SATA3
USB Security Allows you to disable individual or groups of USB ports.
Slot Security Allows you to disable PCIe and PCI slots along with cards plugged into them.
Network Service Boot Enables/disables the computer’s ability to boot from an operating system installed on a network
server. (Feature available on NIC models only; the network controller must be either a PCI
expansion card or embedded on the system board.)
12 Chapter 2 Computer Setup (F10) Utility

HP MultiSeat ms6000 Specifications

General

Brand	HP
Model	MultiSeat ms6000
Category	Server
Language	English