2. Remove the speaker from the computer (2).
NOTE: Be sure that the rubber gaskets are installed in the mounting holes in the speaker (3) before
installation.
Reverse this procedure to install the right speaker.
Card reader
To remove the card reader, use this procedure and illustration.
Table 5-14 Card reader description and part number
Description Spare part number
Card reader M57154-001
Card reader cable M57155-001
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 30).
2. Remove the bottom cover (see Bottom cover on page 30).
3. Remove the battery (see Battery on page 31).
4. Remove the solid-state drives (see Solid-state drive on page 33).
5. Remove the power connector cable (see Power connector cable on page 37).
6. Remove the heat sink (see Heat sink on page 38).
7. Remove the fans (see Fans on page 40).
8. Remove the system board (see System board on page 44).
9. Remove the left speaker (see Speaker, right on page 48).
Remove the card reader:
Component replacement procedures 49
To Next Page
Loading...
Need help?
General
