Inserting or removing a battery
NOTE: Batteries vary in appearance by model.
To insert a battery:
1. Turn the computer upside down on a flat surface, with the battery bay away from you.
2. Insert the battery into the battery bay (1) and rotate it downward until it is seated (2).
The battery release latch (3) automatically locks the battery into place.
To remove a battery:
CAUTION: Removing a battery that is the sole power source can cause loss of information. To prevent
loss of information, initiate hibernation or shut down the computer through Windows before removing
the battery.
1. Turn the computer upside down on a flat surface, with the battery bay away from you.
2. Slide the battery release latch (1) to release the battery.
3. Pivot the battery (2) away from the computer and remove it from the computer (3).
18 Chapter 7 Batteries
To Next Page
Loading...
Need help?
General
