5-25
RADIUS Authentication, Authorization and Accounting
Configuring RADIUS Accounting
Configuring RADIUS Accounting
Note This section assumes you have already:
■ Configured RADIUS authentication on the switch for one or more
access methods
■ Configured one or more RADIUS servers to support the switch
If you have not already done so, refer to “General RADIUS Setup Procedure”
on page 5-5 before continuing here.
RADIUS accounting collects data about user activity and system events and
sends it to a RADIUS server when specified events occur on the switch, such
as a logoff or a reboot. The switch supports three types of accounting services:
■ Network accounting: Provides records containing the information
listed below on clients directly connected to the switch and operating
under Port-Based Access Control (802.1X):
RADIUS Accounting Commands Page
[no] radius-server host < ip-address >5-28
[acct-port < port-number >] 5-28
[key < key-string >] 5-28
[no] aaa accounting < exec | network | system >
< start-stop | stop-only> radius
5-31
[no] aaa accounting update
periodic < 1 - 525600 > (in minutes)
5-31
[no] aaa accounting suppress null-username 5-31
show accounting 5-36
show accounting sessions 5-37
show radius accounting 5-36
• Acct-Session-Id
• Acct-Status-Type
• Acct-Terminate-Cause
• Acct-Authentic
• Acct-Delay-Time
• Acct-Input-Packets
• Acct-Output-Packets
• Acct-Input-Octets
• Nas-Port
• Acct-Output-Octets
• Acct-Session-Time
• Username
• Service-Type
• NAS-IP-Address
• NAS-Identifier
• Called-Station-Id
To Next Page
Loading...
Need help?
General
