HP Storageworks dat 40 User Manual

Installing an internal DAT tape drive16
Install drive
1. Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay, as
shown in Figure 6.
Figure 6 Installing tape drive
If your server does not use mounting hardware, check that the holes in the chassis are aligned
with the holes in the side of the tape drive.
Do not secure the drive at this point because you may have to move the drive to get the cables
into place.

HP Storageworks dat 40 Specifications

General

Brand	HP
Model	Storageworks dat 40
Category	Storage
Language	English