HP Storageworks dat 40 User Manual

HP StorageWorks DAT Tape Drives User Guide 43
2. Expand Universal Serial Bus controllers and locate the tape drive.
3. If the tape drive is connected to the HP USB Mass Storage Device, it is configured correctly. See
Figure 20.
Figure 20 Windows Device Manager, USB controllers
Check drivers (Linux)
Use the following procedure to check that both drivers are present:
1. usb_storage driver
• At the command prompt type:
lsmod | grep usb_storage
• The output of this command should contain a line similar to:
usb_storage 61193 0
• If this line is not present, type:
modprobe usb_storage
at the command line to load the usb-storage driver.

HP Storageworks dat 40 Specifications

General

Brand	HP
Model	Storageworks dat 40
Category	Storage
Language	English