HP Storageworks dat 40 User Manual

HP StorageWorks DAT Tape Drives User Guide 21
Secure the drive
NOTE: The server latches and side views of your server model may not be exactly the same as
shown in the illustrations. Please refer also to you server documentation.
Mounting hardware used (HP ProLiant)
Ensure that you use the correct mounting rails or locating screws, as described in ”Attach mounting
hardware” on page 13. The server also incorporates a locking mechanism to hold the tape drive in
place.
1. Push the server latch down to lock the tape drive into position, as shown in Figure 11.
Figure 11 Securing drive, mounting hardware used
2. Ensure blanking plates are in place over empty bays and replace the cover on the server.
1plastic rail
2server latch
1
2

HP Storageworks dat 40 Specifications

General

Brand	HP
Model	Storageworks dat 40
Category	Storage
Language	English