HP Z210 Series User Manual

7 Installing memory
This section describes how to add memory to your workstation.
Supported memory configurations
Refer to the quick specs at http://www.hp.com/go/productbulletin for specific DIMM compatibility
information for HP workstations.
NOTE:
— Install only HP-approved, unbuffered DDR3 DIMMs.
— HP Z210 CMT and SFF Workstations support Error Checking and Correcting (ECC) and non-ECC
DIMM memory modules.
— Do not intermix ECC and non-ECC memory. The system will not boot and will produce a memory
error.
— For maximum performance, install DIMM memory modules in pairs of the same size.
— Install DIMM memory modules in the order shown below.
The following table describes the memory configurations supported by the HP Z210 Workstations.
Z210 CMT Z210 SFF
Supported configurations
●
Four DIMM slots
●
Memory configuration from 1 GB to 32 GB
Supported configurations
●
Four DIMM slots
●
Memory configuration from 1 GB to 32 GB
DIMM installation order
DIMM installation order
38 Chapter 7 Installing memory ENWW

HP Z210 Series Specifications

General

Brand	HP
Model	Z210 Series
Category	Desktop
Language	English