HUAWEI HG231f Wireless-N Router
User Guide
8 FAQs
Issue 01 (2010-04-01) 8-1
8 FAQs
Q 1: Can I use the router as a DHCP server?
Yes, you can. The router incorporates the DHCP server software.
Q 2:
How can I quickly restore the default settings of the router?
When the router is powered on, press and hold the RESET button for more than 3s, and
then release it. Then the router automatically restarts and the default settings are restored.
Q 3:
What can I do if I cannot access the router configuration page?
Step 1
Check the IP address of your computer and ensure that this
IP address is in the same
Step 3
sword that are used for
blem persists, restore the default settings of the router.
Q 4:
pecial requirement on the wireless
en
network segment as the LAN IP address of the router.
Step 2
Ensure that your Web browser does not use a proxy server.
Ensure that you have entered the correct user name and user pas
accessing the router configuration page.
If the pro
----End
Does the WPS function have any s
cryption settings of the router?
The WPS function can be used only when the security mode of the WLAN is set to
WPA-PSK or WPA2-PSK and the SSID is set to SSID1. It is recommended that you set
Q 5:
o a WLAN after I press and hold the WPS
the security mode to WPA-PSK/WPA2-PSK for the WLAN.
If my PC fails to connect t
button, what should I do?
Step 1
Ensure that only one computer is trying to connect to the router through the WPS
function at a particular moment.
On the router, ensure that the wireless network function and the WPS function
implemented throu
Step 2
gh the PBC method are enabled. Note that on some wireless routers,
the WPS function is forcibly disabled if the WEP encryption is used for accessing a
wireless network.
To Next Page
Loading...
Need help?
General
