SUN2000-43KTL-IN-C1
User Manual
Copyright © Huawei Technologies Co., Ltd.
9 Handling the SUN2000
9.1 Removing the SUN2000
Before removing the SUN2000, disconnect both AC and DC connections. For processes of
disconnecting, see 6.3 Powering Off the SUN2000. After powering off the SUN2000, wait at
least 5 minutes before performing operations on it.
Perform the following operations to remove the SUN2000:
1. Disconnect all cables from the SUN2000, including RS485 communications cables, DC
input power cables, AC output power cables, and PGND cables.
2. Remove the SUN2000 from the mounting bracket.
3. Remove the mounting bracket.
9.2 Packing the SUN2000
If the original packing materials are available, put the SUN2000 inside them and then
seal them by using adhesive tape.
If the original packing materials are not available, put the SUN2000 inside a suitable
cardboard box and seal it properly.
9.3 Disposing of the SUN2000
If the SUN2000 service life expires, dispose of it according to the local disposal rules for
electrical equipment waste.
To Next Page
Loading...
Need help?
General