Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
----End
8.3 SUN2000 Troubleshooting
Alarm severity levels are defined as follows:
Major: The SUN2000 enters Shutdown mode and disconnects from the power grid to
stop generating power after a fault occurs.
Minor: Some components are faulty but the SUN2000 can still connect to the power grid
and generate power.
Warning: The SUN2000 output power decreases due to external factors.
The reset alarm cannot be automatically cleared after the fault is rectified. Choose Device info >
Alarm management > Active alarm on the FusionHome app, as shown in Figure 8-13, to manually
clear it or power off the SUN2000. Powering off the SUN2000 to clear the alarm: Turn off the AC
output switch and then the DC input switch. After 5 minutes, turn on the AC output switch and then
the DC input switch.
Contact your installer if the fault still persists after completing all failure analysis procedures listed
above.
To Next Page
Loading...
Need help?
General