To change the configuration file to be imported, tap Change.
In the dialog box with Are you sure you want to configure the inverter connected router settings
again, if you tap Confirm, the previously saved router configurations will be cleared. If you tap
Cancel, you only have to enter the saved router password.
After quick setting is complete, tap Switch to Router WiFi to switch to the Available WiFi
networks nearby screen and tap the corresponding router WiFi connection to switch to the router
WiFi network.
To connect to the router WiFi network from the mobile phone system after router parameters are
successfully set, you need to log out of the app and log in again.
After the management system is successfully connected, the SUN2000 will report the SN and
installer registration code. If the connection fails, another connection attempt will start after 10
seconds. The installer registration code is generated by the SUN2000 automatically and is used for
the installer to register with the management system and manage the inverter.
Figure 7-15 Home
----End
7.4.2 Querying the Device Information
To query the SUN2000 information, choose Device info from the Home screen.
Querying Device Status
You can query the status of each device.
To Next Page
Loading...
Need help?
General