19
SET STATION RUN TIMES
A
B
C
1
2
3
4
PROGRAM
STAR
T
TIMES
STATION RUN TIME
YEAR
MONT
H
DA
Y
RUNNING
AM
PM
24 HR.
SUN MON
TUES WED
THUR
FRI SAT EVEN
/
ODD
NOTE: One start time will activate all stations
sequentially in that program. This eliminates the
need to enter each station’s start time. Multiple start
times in a program can be used for separate morning,
afternoon, or evening watering cycles.
Eliminating a Program Start Time
With the dial set to the SET PROGRAM START TIMES position, push the
or button until you reach 12:00 AM (Midnight). From here push the
button once to reach the OFF position.
NOTE: If a program has all four start times turned off,
then that program is off. (All other program details
are retained). Because there are no start times,
there will be no watering with that program. This is a
convenient way to stop watering on one program only
without turning the dial to the OFF position.
Setting Station Run Times (Length of Watering for Each Area)
1. Turn the dial to the SET STATION
RUN TIMES position.
2. The display will show the last
program selected (A, B, or
C)
the station number selected,
and the run time for that station
will be flashing. You can
switch to another program by
pressing the
button.
3. Use the
or button to
change the station run time on
the display.
4. Press the
button to advance
to the next station.
5. Repeat steps 3 and 4 for each station.
6. You can set station run times anywhere from 0 to 99 minutes.
7. You can move between programs while staying on the same station.
However, it is recommended that one program is completed before
going on to the next program.
NOTE: Jumping between programs can be confusing
and may result in program entry errors.
To Next Page
Loading...
Need help?
General
