104 72 30-26 Husqvarna service manual 25
3 I. Presser foot, parallelism to the stitch plate
Requirements
The presser foot shall be parallel to the marking lines
(A) on the stitch plate.
Adjustment
Undo the screw (B) and turn the presser foot until
requirement is obtained.
NOTE! This setting must be correct for all the other
settings in the sewing head.
4 II. Setting the presser foot at right angles to the feeding direction.
Requirements
The sewing head should be set in such a way that
the needle hole of the presser foot is in accordance
with the needle hole of the stitch plate.
Adjustment
Undo the screws (D) (turn the pulley for the presser foot
pressure so that the right one becomes available) and
the nut (E).
Shift the sewing head until requirement is obtained.
Tighten the screws (first the left one) and the nut.
Comments
On the underneath of the buttonhole foot there is a guide,
which steers the fabric.
If the position of the presser foot is not correct in relation
to the needle, the distance between the columns
will be affected.
To Next Page
Loading...
Need help?
General
