104 72 30-26 Husqvarna service manual 27
6 Setting of the needle in relation to the presser foot
Requirements
When the machine is set at straight stitching centre
position, the needle bar shall be set in such a way that a
needle 90 passes through the centre of the needle hole
in the presser foot.
1 = seen from the front
2 = seen from the side
Adjustment
Switch on the mainswitch
Keep the machine set at straight stitching centre
position (alt. service mode/program button no 6).
Undo the screws (A) by means of an adam key
412 27 65-01.
Put the adam key into the hole (B) and move the needle Needlepoint
bar until requirement obtains.
Tighten the screws.
Check the setting by switching mains on and off a
couple of times.
Thereafter check:
The gap between the hook and the needle (P.28).
Setting of the stitch plate in relation to the needle (P.29).
To Next Page
Loading...
Need help?
General
