English – 23
OPERATING
• The E-track gauge on the display will indicate the present
angle of the rear axle. This setting will not be saved after
the engine restart.
• Adjustments can be made both while sawing and not
sawing.
• Visually confirm the axle movement and direction.
To set new center angle for E-track.
• Adjust the rear axle to the desired new center angle.
• In the display enter the Setup menu 2 and press calibrate
E-track button. This setting will be saved even after engine
restart.
Saws with manual axle adjustment
• The rear axle is adjusted by turning the adjustment bolt
located at the rear lower left of saw frame with an 18mm
wrench.
• If the saw steers to the right while sawing, turn the
adjustment bolt counterclockwise.
• If the saw steers to the left while sawing, turn the
adjustment bolt clockwise.
Transport and storage
• Remove the blade before transportation or storage of the
machine, to avoid damage to the blade.
• Remove all adjustment tools and wrenches
Transport
The flat saw is not equipped with a parking brake. It will slowly
roll away by itself if left in steep grade or hill. Never leave the
saw unattended in steep grade or hill unless properly scured.
• To go down a ramp, drive the saw backwards slowly.
• To go up a ramp, drive the saw forward slowly.
Lifting the saw
• Observe care when lifting. You are handling heavy parts,
which imply the risk of pinch injuries or other injuries.
• Always use the machine mounted lifting eye when lifting.
To transport by vehicle
• Secure the equipment during transportation in order to
avoid transport damage and accidents. Use the factory
installed tie down lugs on the saw, front and rear to
prevent movement during transport.
• Do not tow this saw with another vehicle as this may
damage drive components.
Storage
Store the equipment in a lockable area so that it is out of
reach of children and unauthorized persons.
• Stop the engine by turning the Engine start switch to the
STOP position.
• Put Speed control lever into the STOP position.
• If there is a risk of freezing, the machine must be drained
of any remaining water coolant in the gearbox.
For transport and storage of fuel and battery, see the section
"Fuel handling" and ”Battery handling”.
For transport and storage of Blades, see the section "Blades".
8
10
12
16
14
V
100
40
60
80
120
c
<1200 RPM
1
2
3
4
c
CURRENT: STOP:
04
cm cm
WORKING HOUR
V
Setup Menu 2
Press MENU button
information
Codes
Calibrate
1
to enter Setup Menu
Fault
E-track
System
Gearbox
and
Blade
info
!
WARNING! When moving the saw up and
down ramps, with engine on, use extreme
caution. For steep ramps, always use a
winch. Never stand below the machine.
Stand only beside.
To Next Page
Need help?
General