24 – English
OPERATING
Long-term storage
Ensure the machine is cleaned and that a complete service is
carried out before long-term storage.
• Remove the blade for storage and store it carefully.
• Grease all nipples before storage.
• Disconnect negative terminal and secure in safe distance
from battery.
• Trickle charge the battery during long-term storage.
• When storing the machine for long periods the fuel tank
must be full. This will minimize condensated water in the
fuel system.
• Store the machine and its equipment in a dry and frost
proof place.
• If the machine is stored outside, cover the machine.
• Check that the engine coolant’s freezing point is adequate
for temperatures where the machine is stored.
• Drain water from gearbox
• Check and empty water in fuel filter water separator.
• Change engine oil after a long-term storage
Engine-Blade shaft-Gearbox speed
adjustment
Engine speed
The engine speed on these machines does not need to be
changed from factory set speed. For more information, see
the ”Technical data” section.
Blade shaft speed
The blade shaft speed on these machines should be checked
before fitting the diamond blade to the machine.
Never install a diamond blade if the blade shaft rotational
speed (n/min) of the machine is greater than the maximum
speed (n/min) marked on the diamond blade.
The blade shaft pulley, outer flange and inner flange may
need to be changed if the diameter of the diamond blade is
changed.
1-Speed gearbox model
Each saw model with single speed gearbox, as delivered from
the factory is configured to operate with one specific blade
size inside the specific blade guard installed on the machine.
If a blade size must be changed to another size, within
available sizes, then the blade drive configuration must be
changed.
Available blade sizes for single speed flat saw models can be
seen in the table.
If changing from a small to a very large diamond blade or vice
versa on a machine with a single speed gearbox, following
must be changed:
• Blade shaft pulleys
• Gearbox pulleys
• Blade shaft flanges
• Belts
• Blade Guard
• Enter gearbox and blade information inside Setup menu 2
on the display to see the specifications for wanted
configuration.
See Blade size conversion charts under heading ”Blade size
conversion” for specific information on necessary parts.
Contact your Husqvarna dealer to order.
Example: FS5000 D 1-Speed gearbox model
To change from 20”/500mm drive to a 36”/900mm drive:
1 Change engine gearbox pulleys from 4.51”/114,5mm
diameter to 3.5”/89mm diameter.
2 Change blade shaft pulleys from 4.17”/106mm diameter
to 5.75”/146mm
3 Change blade shaft flanges (outer and inner) from 4,5”/
114mm to 6”/152,5mm
4 Change blade guard from 20”/500mm to 36”/900mm
5 Change belt from 450”/11430mm to 460”/11684mm
!
WARNING! Serious injury can occur to the
operator or people in the work area if the
rotational speed (n/min) of the diamond
blade exceeds the maximum speed (n/min)
marked on the diamond blade.
Available sizes
FS5000 D, inch/mm FS7000 D, inch/mm
14/350 20/500
20/500 26/650
26/650 30/750
30/750 36/900
36/900 42/1000
Setup Menu 2
Press MENU button
information
Codes
Calibrate
1
to enter Setup Menu
Fault
E-track
System
Gearbox
and
Blade
Information
To Next Page
Loading...
Need help?
General