54 – English
MAINTENANCE AND SERVICE
Stationary regeneration.
Once the stationary regeneration is activated, warning
symbols will be active. The stationary regeneration will
occupy approx. 25-30min run time and will cause engine to
automatically increase to 2300rpm and exhaust temperatures
will increase to 600° C.
The procedure is controlled by the engine control unit and will
do best without help from the operator and no sawing is
possible during the procedure.
It is possible to manually activate stationary regeneration as
a preventive measure, but only after 50h run time after latest
stationary or back up regeneration.
Activate stationary regeneration
• Move the machine to a well ventilated location.
• Check fuel level, make sure there is fuel enough for
specified run time at high engine load.
• Put Speed control lever into the STOP position.
• Start the engine.
• Turn the Throttle knob to low idle.
• Disengage the Blade clutch (if equipped and engaged).
• Enter the stationary regeneration menu.
• Fulfill the requirements:
- Engine running
- Speed control lever in STOP position
- Engine temperature is >60° C
- Blade is not running
- Blade clutch is disengaged
• Press Continue.
• Follow the instructions and press Start regen to confirm
and activate stationary regeneration.
• Let the machine cycle rpm and regenerate the DPF (25-
30min)
• When stationary regeneration is completed, press return
button.
If you get the message Stationary Regeneration Could Not Be
Activated, please contact your service agent.
!
CAUTION! Pay special attention on
clutchless machines, blade starts rotating at
start. For safety reason, do not move the
saw sideways or out of the working area with
blade installed and rotating.
Language
Metric
Celsius
Regen
Setup Menu 1
Press MENU button
2
to enter Setup Menu
NOTICE! Warning symbols in the message window may
flicker during the stationary regeneration process.
Start
Regen
Continue
STOP
ventilated space. Ensure that
the following conditions are
met:
Put machine in a well
Engine Running
Speed CTRL in Neutral
Engine Temerature > 60C
Blade Not Running
Clutch Dissengaged
Start
Regen
Continue
Stationary Regeneration
Machine must be in a well
ventilated place.
Caution for hot exhaust!
Press START to activate
Stationary Regeneration
During Stationary Regeneration
engine RPM will increase to
2300 RPM.
STOP
STOP
Start
Regen
Continue
Stationary Regeneration
activated.
Progress: 50
STOP
Start
Regen
Continue
Stationary Regeneration Is Completed.
Stationary Regeneration
Could Not Be Activated.
Start
Regen
Continue
To Next Page
Loading...
Need help?
General