50 – English
MAINTENANCE AND SERVICE
• Fasten the two horizontal bolts again.
• Loosen the belt tensioning bolts counterclockwise
approximately 1/16 of a turn.
Lubricate front wheels
See instructions under the heading ”Lubrication”.
100 hours service
Replace engine oil and filter
See instructions under the heading ”After the first 50 hours”
Check wheels for wear or damage.
Check rear wheel hubs and wheels for looseness
Check engine air cleaner hose and clamps
The image only shows some of the hoses and clamps.
Check hydraulic system fluid level
• Remove the plug in the inspection opening on the
hydraulic reservoir. The level should be to the bottom edge
of the opening on the hydraulic reservoir, fill if necessary.
Lubricate front axle pivot bearings
See instructions under the heading ”Lubrication”.
250 hours service
Replace the hydraulic system filter.
See instructions under the heading ”After the first 50 hours”
Lubricate blade shaft (2 pumps each end)
See instructions under the heading ”Lubrication”.
Lubricate hydraulic cylinder pivot pin.
See instructions under the heading ”Lubrication”.
Lubricate rear axle bearing.
See instructions under the heading ”Lubrication”.
500 hours service
Replace engine gearbox fluid
Select one of the following options to drain gearbox fluid:
Option 1
• Open the window by removing the plug and suck the oil
out with an oil extractor.
!
CAUTION! Be sure to tension both sides
evenly, do not over tension.
Replace V-belts in complete sets only.
Always re-tension new belts after first 2-4
hours of use.
1
/
16
1
/
16
NOTICE! Do not overfill!
To Next Page
Loading...
Need help?
General