English – 51
MAINTENANCE AND SERVICE
Option 2
• Slip a vessel under the bell housing of the engine. Loosen
the screw and drain the oil. Once the system is empty,
fasten the screw.
• Refill the system by removing the left screw and pour oil
into the tube. Look in the window and fill until the correct
level is reached.
• Refit the screw and follow the steps in reverse order.
Replace hydraulic system fluid
• Remove the plug in the inspection opening on the
hydraulic reservoir and use an oil extractor to suck out the
fluid through the inspection opening.
• Replace the hydraulic system filter. Fill the new filter with
oil and lubricate the seal with a few drops of oil prior to
refitting it.
• Refill the reservoir with new oil. Ensure that machine is
level prior refilling.
Replace engine fuel filter (spin-on-type)
• Remove the fuel filter by turning it counterclockwise.
Replace the fuel filter. Beware of diesel that may spill. Fill
the new filter with diesel and lubricate the seal with a few
drops of diesel prior to refitting it.
FS5000 D
NOTICE! Do not overfill!
NOTICE! Maintenance of the fuel filter should be done after
the valve of the pre-filter is closed.
Make sure the valve is open before you start the engine
(see engine manual)
OIL
To Next Page
Need help?
General