26 – English
Maintenance
Replacing the light bulbs: 322T AWD
For information about the bulb type, see Technical Data.
1 Unscrew the two screws holding the cover on the power
ser
vo housing. One screw on each side.
2 Disconnect the cables from the bulbs.
3 Gently push in the locking mechanism and fold out the
lamps from their br
ackets.
4 Insert the new lamps in the lower slot on the lamp
housing.
5 Press the lamp in place in the locking bracket
6 Fit the lamp holder in the lower slots on the servo housing.
7 Refit the cables and screw the lamp holder on to the servo
housing.
Main fuse
The main fuse is placed in a detachable holder under the
battery case’s cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shor
tly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round.
To improve driving the pressure on the rear tyres can be
reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
IMPORTANT INFORMATION
Having the same air pressure in the tyres is important in
order to achieve the best possible performance as well as
to avoid damage to the machine
To Next Page
Loading...
Need help?
General
