English
–
3
Ser
vice journal
Pre-deliver
y service
1
Charge the battery for 4 hours at max. 3 amp.
2 Fit steering wheel, seat and any optional
equipment.
3 Check and adjust tyre pressure (60 Kpa, 0.6 bar,
9 PSI).
4 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit
should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4
mm / 1/8”
higher than front edge.
Adjust the cutting unit’s cutting height setting so
that the connection rod is tensed at the lo
west
cutting height.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission’s oil
tank.
7 Connect battery.
8 Fill with fuel and start engine.
9 Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Oper
ation of blades.
Seat saf
ety switch.
Lif le
ver safety switch.
The saf
ety switch for the hydrostat pedals.
11 Check the engine speed See the Technical data
section.
12 Check the synchronisation between the front and
rear wheels
. (Only AWD-machines) See the
workshop manual.
13 Tell customer about:
Needs and benefits of following the service
schedule
.
Servicing and the influence of this journal on the
second-hand v
alue of the machine.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems.
Cer
tified:
________________________________________________
Date, mileage, stamp, signature
After the fi
rst 8 hours
1
Change engine oil
2 Change the oil in the gearbox. (Only AWD-
machines)
3 Check the synchronisation between the front and
rear wheels
. (Only AWD-machines)
To Next Page
Loading...
Need help?
General
