English – 27
Maintenance
Checking the engine’s cooling air
intake
Clean the air intake grille in the engine cover behind the
driver’s seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dir
t.
A blocked cooling intake will interfere with the cooling of the
engine
, which can damage the engine.
Fitting the cutting head
1 Place the Rider on a flat surface and apply the parking
brake.
2 Check that the lever for setting the cutting height is in the
lo
west position and that the lifting lever for the cutting unit
is in mowing position.
3 Push the equipment frame down and place the catch
against the fr
ame.
4 Engage the belt in the belt holder.
5 Push the deck in and put the front guide plugs in the
g
rooves on the equipment frame, one on each side.
6 Lift up the cutting unit
7 Push the unit in so that the interior plugs touch the bottom
of the equipment fr
ame’s grooves.
!
WARNING! The cooling air intake rotates
when the engine is running. Mind your
fingers.
!
WARNING! Wear protective glasses when
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
!
WARNING! Observe caution to avoid
trapping your hand.
To Next Page
Loading...
Need help?
General
