Husqvarna TE 250 User Manual

12 SERVICE WORK ON THE CHASSIS
62
12.12 Adjusting steering head bearing play
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 55)
H03689-10
Main work
–
Loosen screws
1
. Remove screw
2
.
–
Loosen and retighten screw
3
.
Guideline
Screw, top steering
head
M20x1.5 12 Nm (8.9 lbf ft)
– Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
Tighten screws
1
.
Guideline
Screw, top triple
clamp
M8 17 Nm (12.5 lbf ft)
–
Mount and tighten screw
2
.
Guideline
Screw, top
steering stem
M8 17 Nm (12.5 lbf ft)
Loctite
®
243™
Finishing work
– Check the steering head bearing for play. ( p. 61)
– Remove the motorcycle from the lift stand. ( p. 55)
12.13 Lubricating the steering head bearing
H02387-01
– Remove the lower triple clamp. ( p. 58)
– Install the lower triple clamp. ( p. 59)
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
12.14 Removing front fender
Preparatory work
– Remove the headlight mask with the headlight. ( p. 111)

Husqvarna TE 250 Specifications

General

Brand	Husqvarna
Model	TE 250
Category	Motorcycle
Language	English