EasyManuals Logo
Home>Hypertherm>Cutter>HyPerformance Plasma HPR260

Hypertherm HyPerformance Plasma HPR260 User Manual

Hypertherm HyPerformance Plasma HPR260
251 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #128 background imageLoading...
Page #128 background image
OPERATION
HPR260 Manual Gas Instruction Manual 4-35
4
All surfaces Dirt or debris Clean surfaces
Erosion, missing material Replace torch
Cracks Replace torch
Internal burn or arcing marks Replace torch
Current ring 1. Dirt or debris Clean
2. Pitted or missing material Replace torch
Threads Wear or damage Replace torch
Bullet connectors Damage Replace torch
O-rings 1. Damage Replace o-ring
2. Lubricant Apply a thin film of silicone lubricant if dry
External o-rings 1. Damage Replace o-ring
2. Lubricant Apply a thin film of silicone lubricant if dry
Water tube* 1. Tightness Tighten or replace tube*
2. Pitted or missing material Replace tube*
*See Replace torch water tube later in this section.
Inspect Check for Action
Inspect torch
Plasma gas
Plasma vent
Coolant in
Pilot arc
Shield gas
Water
tube
Current
ring
Coolant return
Bullet connectors

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hypertherm HyPerformance Plasma HPR260 and is the answer not in the manual?

Hypertherm HyPerformance Plasma HPR260 Specifications

General IconGeneral
BrandHypertherm
ModelHyPerformance Plasma HPR260
CategoryCutter
LanguageEnglish

Related product manuals