HyPrecision Predictive waterjet pump Operator Manual 810120 153
7 – Troubleshooting
Troubleshooting
To acknowledge an alarm, touch the screen. It changes to an interactive screen.
Touch Ack (acknowledge) or Ack All (acknowledge all) on the screen. The beacon light stops flashing and the
alarm screen closes.
Warnings
The controller battery is not operating correctly.
Contact a Hypertherm Technical Service Associate for information and support.
The boost motor or the fan motor did not start because the thermal overload relay has tripped.
Reset the relay.
4. Find the thermal overload relay on the motor starter.
5. Turn the knob clockwise to the
ON position (I).
6. Release the knob. It snaps counterclockwise to the
OFF position (O).
7. Turn the knob clockwise to the
ON position (I) again.
The dirty water container is full.
Empty the container. Refer to step 1 of Examine and clean the equipment on page 76.
Warning: Battery Error
Warning: Boost Motor
Warning: Fan Motor
Tripped position On position Off position
Warning: Empty the Dirty Water Container
To Next Page
Loading...
Need help?
General
