SC-24 Safety and compliance
Symbols and marks
Symbols and marks
Symbols and marks found on the equipment
Some symbols or marks in this table could apply to other products.
This symbol identifies tools or materials that are necessary or recommended for a procedure.
This symbol identifies information that could cause the user to fail at the task if ignored.
This symbol identifies a tip or helpful information.
DANGER
ARC FLASH AND SHOCK HAZARD
Follow ALL requirements in NFPA 70E for safe work practices and for Personal Protective
Equipment.
DANGER
DANGER
Do not remove, destroy, or cover this label.
Read instruction manual carefully before installing, operating, or servicing this equipment.
High voltage and rotating parts will cause serious or fatal injury.
1. Turn off and lock out power before service or maintenance.
2. Do not insert any object into fan cover, air inlet, or outlet windows before or during
running.
3. Ground and protect per national electric code and local codes.
WARNING
HAZARDOUS VOLTAGE
Disconnect power before servicing.
WARNING
Do not operate this equipment without the guard installed.
WARNING
Risk of explosion
WARNING
WARNING
This product can expose you to chemicals including lead and lead compounds, which are known
to the State of California to cause cancer and birth defects or other reproductive harm. For more
information go to www.p65warnings.ca.gov
Connections may come loose during shipping and normal operation.
Hydraulic, water, and electrical connections can come loose during shipping and normal
operation. It is recommended that all connections are checked at installation and annually.
CAUTION
Do not touch a hot surface.
ATTENTION
Interlock installed
High-pressure cutting water is disabled when the top cover is open.
To Next Page
Loading...
Need help?
General
