Hypertherm POWERMAX 800 User Manual

2-5
Service Manual
DESCRIPTION & SPECIFICATIONS
WARNING
The voltage between the tip of the torch and the workpiece will exceed 113VDC if
shielded consumable parts are not installed in the torch. If using the 400V CE
power supply, the PAC121TS torch must be operated with shielded parts to main-
tain the S mark and CE low-voltage compliance for hand held applications. See
Figure 2-5 below and also Section 5:
Consumable Parts - For CE Compliance for a
list of CE consumable parts. This requirement does not apply to machine torch
applications.
S MARK
The Powermax800 conforms to standard EN50192. The S mark indicates that the power
supply and torch are suitable for use in environments with increased hazard of electrical shock. The
torches must have shielded consumable parts to maintain S mark compliance. See warning below
and Figure 2-5.
7-99
Figure 2-5 S Mark Label.
120438
120601
120602
120608
120573

Hypertherm POWERMAX 800 Specifications

General

Brand	Hypertherm
Model	POWERMAX 800
Category	Cutter
Language	English