Need help?Do you have a question about the Hypertherm Powermax45 XP and is the answer not in the manual?
General| Output Current | 10-45 A |
|---|---|
| Gas Supply | Clean, dry, oil-free air or nitrogen |
| Torch Style | Handheld or mechanized |
| Input Voltage | 50/60 Hz |
| Cutting Thickness | 12 mm (1/2") |
| Cutting Capacity | 16 mm (5/8 in) |
| Recommended Gas Inlet Flow Rate/Pressure | 6.2 bar |
To Next Page
