Hypertherm powermax65 User Manual

OperatiOn
powermax 65/85 Operator Manual 4-15
Start a cut from the edge of the workpiece
1. With the work clamp attached to the workpiece, hold the
torch nozzle perpendicular (90°) to the edge of the workpiece.
2. Press the torch’s trigger to start the arc. Pause at the edge
until the arc has cut completely through the workpiece.
3. Drag the torch tip lightly across the workpiece to proceed
with the cut. Maintain a steady, even pace.

Hypertherm powermax65 Specifications

General

Brand	Hypertherm
Model	powermax65
Category	Welding System
Language	English