955
Maintenance
Back-up light bulb
5. Remove the socket from the assembly
by turning the socket
counterclockwise until the tabs on the
socket align with the slots on the
assembly.
6. Remove the bulb from the socket by
pulling the bulb out.
7. Insert a new bulb by inserting it into
the socket.
8. Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly. Push the
socket into the assembly and turn the
socket clockwise.
High mounted stop light
replacement (if equipped)
1. Open the tailgate.
2. Remove the nut by turning it
counterclockwise.
3. Push in the three stud bolt. The high
mounted stop light assembly will
slighty pop out.
4. Disconnect the bulb electrical
connector (1) by pressing the clip.
OHA071033 OHA071034 OHA071035
Back-up light
To Next Page
Loading...
Need help?
General
