15 28
Checking Oil Level
1. Remove the oil filler cap and wipe the
dipstick clean.
2. Refit the dipstick without screwing it down.
3.Remove the dipstick and check the oil level.
It should be up to the upper mark on the
dipstick. DO NOT overfill. The oil level should
not be above the upper mark on the dipstick.
4. If the oil level is too low, add SAE 30 engine
oil part number ‘600MLSAE30OIL’ or 15W40
engine oil, to the upper mark on the dipstick
(as shown below).
5. Once the correct amount of oil has been
added, refit the dipstick securely.
NOTE - All machines are pre delivery
inspected so there may be some residual oil
left in the machine so please fill with caution.
If you overfill the oil, you can remove some by
gently tilting the machine on its side and
pouring out any excess oil into a suitable
container or use an oil change syringe.
You should change the oil every 100 hours or
every 12 months, whichever is sooner.
Maintenance & Care
Filling The Fuel Tank
1. Remove the fuel filler cap.
2. Fill the fuel tank with fresh straight unleaded
petrol. Allow a 25mm gap from the top of the
tank. DO NOT mix petrol with oil and clean up
any spills immediately.
DO NOT overfill. The fuel tank only needs
to contain enough fuel to complete the days
mowing. If you run out of fuel, refilling must
only be done once the engine has cooled
down. Fuel stored within the machine for 28
days or more can go stale and should be
drained before further use.
3. Refit the fuel filler cap securely and clean up
any fuel split before starting the engine.
CAUTION - ALL FUELS ARE FLAMMABLE
ALWAYS fuel and defuel in a well ventilated area
outside of buildings.
ALWAYS wear correct, suitable and fit for
purpose Personal Protective Equipment (PPE),
suggested items are but not limited to safety
gloves, overalls and work boots.
!
To Next Page
Loading...
Need help?
General
