1
FEATURES OF YOUR HYUNDAI
10
THEFT-ALARM SYSTEM
B070B01O-GAT
Armed Stage
!
Park the car and stop the engine. Arm
the system as described below.
CAUTION:
Do not arm the system until all
passengers have left the car. If the
system is armed while a
passenger(s) remains in the car,
the alarm may be activated when
the remaining passenger(s) leaves
the car.
B070B01FC
UNLOCK
LOCK
B070C01FC-GAT
Alarm Stage
The alarm will be activated if any of the
following occurs while the car is parked
and the system is armed.
1) A front or rear door is opened with-
out using the transmitter.
2) The tail gate is opened without us-
ing the transmitter.
3) The hood is opened.
The alarming horn will sound and the
turn signal light will blink continuously
for 27 seconds (E.C only/ Except E.C
3 times). To turn off the system, unlock
the door or tail gate with the transmit-
ter.
B070A01A-AAT
(If Installed)
This system is designed to provide
protection from unauthorized entry into
the car. This system is operated in
three stages: the first is the "Armed"
stage, the second is the "Alarm" stage,
and the third is the "Disarmed" stage.
If triggered, the system provides an
audible alarm with blinking of the turn
signal lights.
1) Remove the ignition key from the
ignition switch.
2) Make sure that the engine hood and
tail gate are locked.
3) Lock the doors using the transmitter
of the keyless entry system.
After completion of the steps above,
the turn signal lights will blink once to
indicate that the system is armed.
NOTE:
1) If any door, the tail gate or engine
hood remains open, the system
will not be armed.
2) If this happens, rearm the system
as described previous.
To Next Page
Loading...
Need help?
General
