6
OWNER MAINTENANCE
34
G290A01FC
5. Open the bonnet.
6. Draw the vertical line (through the
centre of each headlight beam pat-
tern) and the horizontal line (through
the centre of each headlight beam
pattern) on the aiming screen.
And then, draw the horizontal paral-
lel line at 1.18 in. (30 mm) under the
horizontal line.
7. Adjust each cut-off line of the low
beam to the parallel line with a phillips
screwdriver - VERTICAL AIMING
8. Adjust each cut-off line of the low
beam to each vertical line with a
phillips screwdriver - HORIZONTAL
AIMING.
Horizontal Aiming
Vertical Aiming
HEADLIGHT AIMING
ADJUSTMENT
G290A01FC-EAT
Before performing aiming adjustment,
make sure of the following.
1. Keep all tyres inflated to the correct
pressure.
2. Place the vehicle on level ground
and press the front bumper & rear
bumper down several times. Place
the vehicle at a distance of 118 in.
(3,000 mm) from the test wall.
3. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tyre,
jack, and tools).
4. Clean the head lights lens and turn
on the headlight (Low beam).
!
WARNING:
o Do not smoke or have any other
open flame near the vehicle whilst
bleeding the fuel system.
o Be sure to carefully wipe away
any water drained out in this
manner, because the fuel mixed
in the water might be ignited and
result in a fire.
Extracting air in the fuel filter
If you drove until you have no fuel left
or if you replaced the fuel filter, be sure
to extract air in the fuel system as it
makes you difficult to start the engine.
1) Remove the air extract nozzle cap
on the fuel filter.
2) Pump up and down until the fuel
flows out of the plug opening.
NOTE:
Use cloths when you extract air so
that the fuel is not sprayed around.
Clean the fuel around the fuel filter
or the injection pump before start-
ing the engine to prevent fire. Fi-
nally, check each part if the fuel is
leaking.
fcuk-6.p65 12/27/2006, 10:16 AM34
To Next Page
Loading...
Need help?
General
