8
CONSUMER INFORMATION
5
!
SI060D3-E
WHEEL REPLACEMENT
The original wheels may only be re-
placed with Hyundai Approved wheels.
Tyres of different size, construction or
tread pattern should not be intermixed
on the same axle. Radial and cross ply
tyres should not be used on the same
vehicle.
The use of tyres and wheels of non
approved sizes can be dangerous.
WARNING:
o Driving on worn or defective tyres
is dangerous. Worn tyres may
cause loss of steering control
and a serious deterioration of
braking efficiency. Defective tyres
may cause vibration and loss of
control through blow outs.
o Your vehicle is equipped with
tyres designed to provide for safe
ride and handling capability.
Do not use a size and type of tyre
and wheel that is different from
the one that is originally installed
on your vehicle.
SI060B1-E
TYRE REPLACEMENT
0.06 in.(1.6 mm)
Wear indicator
I090A02FC
Tyres must be replaced when the wear
indicators appear as a solid bar across
the tyre tread. At this point, the re-
maining tread depth will be approxi-
mately 0.06 in.(1.6 mm). In addition to
this, the tyre must be replaced if any
portion of the tread has become bald
or if there are any lumps, bulges or
deep cuts in the sidewalls or tread.
Replacement tyres must be of the
recommended size and rating and
should be of the same manufacture
and tread pattern on each axle.
It can affect the safety and perfor-
mance of your vehicle, which
could lead to handling failure or
rollover and serious injury.
When replacing the tyres, be sure
to equip all four tyres with the
tyre and wheel of the same size,
type, tread, brand and load-carry-
ing capacity. If you nevertheless
decide to equip your vehicle with
any tyre/wheel combination not
recommended by Hyundai for off-
road driving, you should not use
these tyres for highway driving.
o Tyres degrade over time, even
when they are not being used.
Regardless of the remaining tread,
it is recommended that tyres gen-
erally be replaced after six (6)
years of normal service. Heat
caused by hot climates or fre-
quent high loading conditions can
accelerate the aging process.
Failure to follow this warning can
result in sudden tyre failure, which
could lead to a loss of control
and an accident involving seri-
ous injury or death.
fcuk-8.p65 12/27/2006, 10:17 AM5
To Next Page
Loading...
Need help?
General
