IBM 8183 - ThinkCentre S50 User Manual

Removing and replacing the power supply assembly
Important
Before you install or remove any component, read “Important safety
information” on page v. These precautions and guidelines will help you work
safely.
To remove and replace the power supply assembly, do the following:
1. Turn off the computer and disconnect the power cord from the electrical outlet
and from the computer.
2. Open the cover (see “Opening the cover” on page 10).
3. Rotate the drive bay assembly upward to gain access to the cable connections.
4. Locate the power supply assembly. See “Locating components” on page 11.
Note: Take note of the routing of the power supply cables. It is important to
route the cables the same way when installing a new power supply
assembly.
5. Disconnect the power cables (P3 and P4) from the hard disk drive and the
CD-ROM drive.
Appendix A. Replacing customer replaceable units (CRU) 31

IBM 8183 - ThinkCentre S50 Specifications

General

Brand	IBM
Model	8183 - ThinkCentre S50
Category	Desktop
Language	English