the sequence number); nnnnn is the problem number; SFaESSbc is
the logical partition name; ssssssssss is the system reference code
(SRC); and FruNLoc is the location code of FRU N, where n is 1, 2,
and 3.
Specific trap 100 - Remote mirror and copy links degraded
This trap displays when an established remote mirror and copy
path between a primary and secondary logical subsystem pair
becomes inoperable, but there is at least one operational path
remaining between the two logical subsystems. The following
information is provided for specific trap 100:
ssEventDescr=yyyy/MM/dd hh:mm:ss tzn
-error_description-
UNIT: Mnf Type-Mod SerialNm LS
PRI: xxx tttt-ooo pp-zzzzz ll
SEC: xxx tttt-ooo pp-zzzzz ll
Path: Type PP PLink SP SLink RC
1: aaaaa bbbb cccccc dddd eeeeee gg
.
.
.
w: aaaaa bbbb cccccc dddd eeeeee gg
where yyyy/MM/dd hh:mm:ss tzn is the time that the alert was sent
(year, month, day, hour, minute, second, and time zone);
-error_description- is the event description; xxx is the manufacturer;
tttt-ooo is the machine type and model number; pp-zzzzz is the
serial number (a combination of the plant of manufacture and the
sequence number); ll is the LSS number in hexadecimal format;
aaaaa is ″ESCON″ or ″FIBRE″; bbbb is the primary I/O port number;
cccccc is the primary link address in hexadecimal format; dddd is
the secondary port number for ESCON direct connection or FIBRE
(this value is XXXX if you are connected through an ESCON
switch); eeeeee is the secondary link address in hexadecimal format;
gg is the reason code in hexadecimal format (see Table 5) if there is
a problem (otherwise, gg is ″OK″ if there is no problem); and w
represents the last of up to 8 path descriptions. Only established
paths are listed.
Table 5 lists remote mirror and copy return codes that can appear
for gg.
Table 5. Remote mirror and copy return codes
Return
code Return code explanation
X’02’ Initialization failed. The ESCON link rejected threshold was exceeded when
attempting to send ELP or RID frames.
X’03’ Timeout. No reason is available.
X’04’ There are no resources available in the primary storage unit for establishing
logical paths because the maximum number of logical paths have already been
established.
X’05’ There are no resources available in the secondary storage unit for establishing
logical paths because the maximum number of logical paths have already been
established.
X’06’ There is a secondary storage unit sequence number, or logical subsystem
number, mismatch.
160 DS8000 User’s Guide
To Next Page
Loading...
Need help?
General