Use Table 80 to enter the appropriate response into the information column.
Table 80. Control switch settings work sheet
Control Switch
Setting Default Your information
IBM i LUN Serial
Suffix number -
AS/400 LUN Serial
Suffix number
0 (Off) _____ Enter the last three digits of the DS8000
worldwide node name (WWNN).
1
[]0=Off(use last three digits of WWNN)
[ ] _____ (enter three numeric digits to
create a unique identifier)
CUIR support 0
(Disable)
[ ] true = Enable CUIR support
[ ] false = Disable CUIR support
Control unit threshold 2 Present SIM to operator console for the following
severities:
[ ] 0 = Service, Moderate, Serious, and Acute (all)
[ ] 1 = Moderate, Serious and Acute
[ ] 2 = Serious and Acute
[ ] 3 = Acute
Device threshold 2 Present SIM to operator console for the following
severities:
[ ] 0 = Service, Moderate, Serious, and Acute (all)
[ ] 1 = Moderate, Serious and Acute
[ ] 2 = Serious and Acute
[ ] 3 = Acute
Media threshold 2 Present SIM to operator console for the following
severities:
[ ] 0 = Service, Moderate, Serious, and Acute (all)
[ ] 1 = Moderate, Serious and Acute
[ ] 2 = Serious and Acute
[ ] 3 = Acute
Present SIM data to
all hosts
0
(Disable)
[ ] true = Enable (all hosts)
[ ] false = Disable (host issuing start I/O)
Notes:
1. The WWNN can only be determined by reading the WWNN label on the front left
inside wall of Rack-1 after it is unpacked. Only then can you determine if there is a
duplication of the last three digits with an existing storage facility. If you cannot wait
for that to occur, enter three numeric digits to create a unique identifier.
Appendix H. Control switch settings work sheet 219
To Next Page
Loading...
Need help?
General