Chapter 3. Installing software
This chapter describes how to install and configure software for your IBM
IntelliStation M Pro Types 6220 and 6230 computers.
Viewing the license agreement
The IBM International License Agreement for Non-Warranted Programs is viewable
from the Access IBM folder. Use of your computer signifies acceptance of this
agreement.
Complete the following steps to view the license agreement in Windows XP:
1. From the Windows XP desktop, click Start → All Programs → Access IBM.
2. Select IBM License Agreement.
Complete the following steps to view the license agreement in Windows 2000:
1. From the Windows 2000 desktop, click Start → Programs → Access IBM.
2. Select IBM License Agreement.
For Red Hat Linux, when you start your computer, the License Agreement window
opens. To accept the terms of the agreement, click I Agree. You can also view the
license agreement by clicking on the IBM License Agreement icon on your
desktop.
Using the built-in configuration programs
The following configuration programs are available to configure your computer:
v Configuration/Setup Utility program
This program is part of the basic input/output system (BIOS) code in your
computer. You can use this program to configure serial- and parallel-connector
assignments, change the drive startup sequence, set the date and time, and set
passwords. For more information on how to start this utility, see “Starting the
Configuration/Setup Utility program” on page 46. For detailed information, see the
User’s Guide.
v Intel Gigabit Ethernet Utility program
The Intel Gigabit Ethernet Utility is part of the BIOS code in your computer. You
can use it to configure the network as a startable device, and you can customize
where the network startup option appears in your startup sequence. Enable the
Intel Gigabit Etherne Utility from the Configuration/Setup Utility program. For
information about how to enable this utility, see “Starting the Intel Gigabit
Ethernet Utility program” on page 46.
v SCSISelect Utility program (some models)
With the SCSISelect Utility program, you can configure the devices that are
connected to the optional SCSI adapter. Use this program to change default
values, resolve configuration conflicts, and perform a low-level format on a SCSI
hard disk drive. For information about how to start this utility, see “Starting the
SCSISelect utility program (some models)” on page 46.
v Ethernet controller configuration
To configure the integrated Gigabit Ethernet controller, see “Configuring the
Gigabit Ethernet controller” on page 47.
© Copyright IBM Corp. 2003 45
To Next Page
Loading...
Need help?
General
