2. Ensure that the electromagnetic compatibility (EMC) access plate is installed over the power supplies.
3. Ensure that the card retainers are installed on the front and back of the card enclosure.
4. Ensure that the latch to lock the bottom adapter card is installed on all Magnetic Storage IOP (2624)
cards with part number 86G8317.
5. Ensure that the safety shield is installed over the left side of the expansion unit AMD assembly.
6. Check the external battery backup power supply cable (if present) for visible cracks, wear, or damage.
Models 640, 730, and S30 only:
1. Ensure that the retainer that holds the vertical SPD card separators is in place.
2. Ensure that the vertical rods between DASD units are in place (model 640, 730 and S30 only).
3. Ensure that the EMC access plate is installed over the charger and internal battery unit.
4. Ensure that the EMC access plates are installed over all cages.
Service log
For use by authorized service providers.
Machine type ____________
Serial number ____________
Logical partition ___________
Date
Description of problem/action
taken (do not record hours or part
numbers.) Service representative
588 Hardware (Remove and Replace; Part Locations and Listings)
To Next Page
Loading...
Need help?
General