IBM NetVista Hardware Maintenance Guide

Check Procedures 73
NOTE: If the monitor was not sold together with the
system unit, you may need to refer to the
service information provided with the monitor.
002 - IS THE SCREEN READABLE? (YES, READ
AHEAD. NO, GO TO STEP 004)
NOTE: If the screen shows a blinking cursor with no
memory count running, answer this question
“No.”
•
Select Interactive Tests from the Main Menu.
•
Select and execute Video test from the menu.
•
Follow the prompts and perform the video test.
•
Go to“Index of Symptoms, Messages, Error
Codes, or Beeps” on page 38.
•
You might have to adjust the monitor controls to
obtain the best image.
003 - DOES THE MONITOR SUCCESSFULLY
PASS ALL TESTS? (YES, READ AHEAD. NO, G
TO STEP 004)
•
You have successfully completed the video
diagnostics tests. If the problem remains, go to
“Index of Symptoms, Messages, Error Codes, or
Beeps” on page 38
•
End.
004 -
•
Power off the system unit.
•
Remove the hard disk drive system cable.
•
Power on the system unit.
005 - IS THE SCREEN STILL NOT READABLE?
•
Replace the monitor. If the symptom remains,
replace the system board.
•
End.

IBM NetVista Specifications

General

Brand	IBM
Model	NetVista
Category	Desktop
Language	English