SAS Device Cables 2-9
drives and the SATA II physical drives. The following figure shows how
to connect the internal SAS cable from the controller to the drives.
Follow these steps to connect the controller with internal connectors to a
physical drive.
Step 1. Plug the connector on the internal cable into the internal
connector on the controller.
Step 2. Plug the connector on the other end of the internal cable into
the connector on the SAS physical drive or the SATA II physical
drive.
Step 3. If you have another physical drive, connect it to another plug
on the internal cable.
You can connect other devices if the cable has more
connectors.
Figure 2.5 Connecting the ServeRAID M5014/M5015 Controller
Internal Connectors to a Physical Drive
To Next Page
Loading...
Need help?
General
