About this task
The Fibre Channel cables are connected in pairs. Both canisters must have the
same number of cables connected.
Procedure
To install the cables, complete the following steps.
If optional 4-port 10 Gbps Ethernet host interface adapters are installed in the node
canisters, connect each port to the network that will provide connectivity to that
port. To provide redundant connectivity, connect both node canisters in a control
enclosure to the same networks.
Results
Figure 131 shows an example Storwize V5010 configuration that uses 10 Gbps
iSCSI-FCoE 4-port host interface adapters.
Figure 132 shows an example of a Storwize V5020 configuration that uses 10 Gbps
iSCSI-FCoE 4-port host interface adapters.
Figure 133 on page 150 shows an example of a Storwize V5030 configuration that
uses 10 Gbps iSCSI-FCoE 4-port host interface adapters.
Figure 131. Example Storwize V5010 configuration with 10 Gbps iSCSI-FCoE 4-port host
interface adapters
Figure 132. Example Storwize V5020 configuration with 10 Gbps iSCSI-FCoE 4-port host
interface adapters
Chapter 2. Installing the system hardware 149
To Next Page
Loading...
Need help?
General