System board
(7 screws)
5. Install the seven screws that secure the system board to the chassis.
6. Install any of the following components that you removed from the system
board:
v SAS/SATA ServeRAID adapter (see “Installing a ServeRAID adapter” on
page 178).
v Battery (see “Installing the system battery” on page 209).
v DIMMs (see “Installing a memory module” on page 203).
v Microprocessor and heat sink (see “Installing a microprocessor and heat
sink” on page 254).
v Adapters (see “Installing a ServeRAID adapter” on page 178).
7. Reconnect any cables to the system board that you disconnected during
removal (see “System-board internal connectors” on page 17).
8. Secure the cables with the retention-clips.
9. Install the air duct.
10. Install the side cover (see “Installing the side cover” on page 167).
11. Stand the server back up in its vertical position.
12. Install bezel (see “Installing the bezel” on page 171).
13. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Important: Perform the following updates:
v Either update the server with the latest RAID firmware or restore the pre-existing
firmware from a diskette or CD image.
v Update the UUID (see “Updating the Universal Unique Identifier (UUID)” on page
286).
v Update the DMI/SMBIOS (see “Updating the DMI/SMBIOS data” on page 289).
v Clear the CMOS data (see JP1 in “System-board switches and jumpers” on page
19).
Chapter 5. Removing and replacing server components 263
To Next Page
Loading...
Need help?
General