IBM System x3300 M4 User Manual

Starting the LSI Configuration Utility program
Use these instructions to start the LSI Configuration Utility program.
To start the LSI Configuration Utility program, complete the following steps:
1. Turn on the server, and make sure that the server is the owner of the keyboard,
video, and mouse.
2. When the prompt message is displayed, you may perform either of the
following:
a. ServeRAID-H1110: press Ctrl+C.
b. ServeRAID-M5110, ServeRAID-M5120,orServeRAID-M1115: press
Ctrl+H.
When you have finished changing settings, press Esc to exit from the program;
select Save to save the settings that you have changed.
Starting the Human Interface Infrastructure (HII) Configuration
Application
Use these instructions to start the Human Interface Infrastructure (HII)
configuration utility program.
To start the Human Interface Infrastructure (HII) configuration utility program,
complete the following steps:
1. Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power,
the power-control button becomes active after the power-on LED flashes slowly.
2. When prompted, <F1 Setup> is displayed, press F1. If you have set an
administrator password, you are prompted to type the password.
3. Under System Settings, select Storage.
When you have finished changing settings, press Esc to exit from the program;
select Save to save the settings that you have changed.
Creating RAID of hard disk drives (ServeRAID-C105 only)
Note:
1. If there is a RAID adapter in PCIe slot, ServeRAID-C105 will not work.
2. ServeRAID-C105 uses HII only for configuration and there is no legacy
configuration utility.
To create RAID of hard disk drives (ServeRAID-C105 only), complete the following
steps:
1. Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power,
the power-control button becomes active after the power-on LED flashes
slowly.
2. When prompted, <F1 Setup> is displayed, press F1. If you have set an
administrator password, you are prompted to type the password.
3. Under System Settings, select Storage.
4. Under Storage, select ServeRAID C105.
5. Under Configuration Options, select Virtual Drive Management → Create
Configuration.
Chapter 3. Configuration information and instructions 129

IBM System x3300 M4 Specifications

General

Brand	IBM
Model	System x3300 M4
Category	Server
Language	English