Removing and replacing consumable and structural parts
Replacement of consumable parts and structural parts is your responsibility. If IBM
installs a consumable part or structural part at your request, you will be charged
for the installation.
The illustrations in this document might differ slightly from the hardware.
Removing the bezel
To remove the bezel, complete the following steps:
1. Read the safety information that begins in Safety and “Installation guidelines”
on page 36.
2. Turn off the server (see “Turning off the server” on page 24) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Pull the bezel out slightly until the tabs on the right-side of the bezel
disengages from the chassis and set it aside.
4. If you are instructed to return the front bezel, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Chapter 6. Removing and replacing components 331
To Next Page
Loading...
Need help?
General