12. Connect power and signal cables to the drive and the connectors on the
system board (see “Internal Cable Routing and Connectors” on page 47).
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 104.
Removing an optional tape drive:
To remove an optional full-height tape drive, complete the following steps:
1. Read the safety information that begins in Safety and “Installation guidelines”
on page 36.
2. Turn off the server (see “Turning off the server” on page 24) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Unlock and remove the left-side cover (see “Removing the left-side cover” on
page 39)
4. Open the bezel (see “Removing the bezel” on page 331)
5. Disconnect power and signal cables to the drive and the connectors on the
system board (see “Internal Cable Routing and Connectors” on page 47)
6. Remove the air baffle if installed (see “Removing the air baffle” on page 41)
7. Remove the fan assembly (see “Removing the fan assembly” on page 42)
8. Pressing the drive rail on the side of the tape drive and grasp the front of tape
drive out of the server.
354 System x3300 M4 Type 7382: Installation and Service Guide
To Next Page
Loading...
Need help?
General