Installing the optional two-port Ethernet adapter
Use this information to install the optional two-port Ethernet adapter.
About this task
To install the Ethernet adapter, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page v and
“Installation guidelines” on page 43.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see “Removing the cover” on page 51).
4. Remove the PCI riser-card assembly (if installed) from PCI riser connector 1
(see “Replacing a PCI riser-card assembly” on page 68).
5. Attach the rubber stopper on the chassis, along the edge of the system board,
as shown in the following illustration.
6. Remove the adapter filler panel on the rear of the chassis (if it has not been
removed already).
7. Install the two standoffs on the system board.
Rubber
stopper
Ethernet
adapter connector
Rubber
stopper
Figure 58. Rubber stopper
Figure 59. Filler panel removal
Chapter 2. Installing optional devices 87
To Next Page
Loading...
Need help?
General