If the problem is not corrected, replace the device and then
the system board.
TrackPoint III Checkout
If the TrackPoint III does not work, check the configuration
in the ThinkPad Features program. If the configuration of
the TrackPoint III is disabled, select Enable to enable it.
If this does not correct the TrackPoint III problem, continue
with the following.
The TrackPoint III does automatic compensations to adjust
the pointer sensor. During this process, the pointer moves
on the screen automatically for a short time. This
self-acting pointer movement can occur when a slight,
steady pressure is applied to the TrackPoint III pointer
while the computer is powered on or while the system is
running, or when readjustment is required because the
temperature has exceeded its normal temperature range.
This symptom does not indicate a hardware problem. No
service actions are necessary if the pointer movement
stops in a short period of time.
If a click button problem or pointing stick problem occurs,
do the following:
1. Go to the Easy-Setup screen.
2. Select an item with the pointing stick.
3. Press either the left or right click button.
4. Verify that both buttons work correctly.
If either the pointing stick or the click button do not work,
do the following actions one at a time to correct the
problem. Do not replace a nondefective FRU.
 Reseat the keyboard cables.
 Replace the keyboard.
 Replace the system board.
Diskette Drive Checkout
Do the following to isolate the problem to a controller,
drive, or diskette. A scratch, write-enabled, nondefective
2HD diskette is required.
FDD-1
represents an external diskette drive attached
through the external diskette drive connector.
FDD-2
represents the port replicator.
Warning: Make sure that the diskette does not have
more than one label attached to it. Multiple labels can
cause damage to the drive or cause the drive to fail.
Do the following to select the test device:
1. Go to the advanced diagnostic mode by pressing
Ctrl+A from the diagnostic menu.
2. Select Tool; then select the FDD-1 or FDD-2 icon
and press the spacebar. A √ mark appears next to
the selected icon.
130 IBM Mobile Systems HMM
To Next Page
Loading...
Need help?
General
